In this chapter a first application of PLAXIS 3D is considered, namely the settlement of a foundation in clay. This is the first step in becoming familiar with the practical use of the program.
The general procedures for the creation of a geometry, the generation of a finite element mesh, the execution of a finite element calculation and the evaluation of the output results are described here in detail. The information provided in this chapter will be utilised in the following lessons. Therefore, it is important to complete this first lesson before attempting any further tutorial examples.
The attached (zipped) *.p3dlog files contain all the commands to generate the models up to calculation (without point for curves selection). With a PLAXIS VIP licence you can use the commands runner to open the *.p3dlog file and to execute all commands in one go. Without a VIP licence, you can open the *.p3dlog file with any text editor, like Notepad, and then execute the commands via the command line command by command.
The post PLAXIS 3D Tutorial 01: Foundation in overconsolidated clay appeared first on Plaxis.